3/14/2024 0 Comments How to change horns in run 8 v2The center two bearings are set from the outside. In the two center holes of the lower servo case set in the two 6704ZZ (20x27x4mm) bearings. To set the bearings in the servo tray I used a socket of the right size to tap evenly on them. Use two 693ZZ (3x8x4mm) bearings in the upper servo case one at each end and tap them in from the inside I order a few extra of each screw just in case my count was off. Phillips self tapping screws M1.7 x 8mm About 150 piecesĢx M3 x 14mm self tapping screws for leg gears 16 in allġx M3 x 23mm self tapping screws for hip 4 in allĢx M3 washers per leg, between leg gear and bearings (693ZZ) 12 in all Valefod 10 Pack DC to DC High Efficiency Voltage Regulator 3.0-40V to 1.5-35V Buck Converter DIY Power Supply Step Down ![]() Samsung (MB-ME32GA/AM) 32GB 95MB/s (U1) microSDHC EVO Select Memory Card with Full-SizeĪdapter WHDTS 20A Power Supply Module DC-DC 6V-40V to 1.2V-35V Step Down Buck Converter Adjustable Buck Adapter CVCC Constant Voltage Constant Current Converter LED Driver. ![]() use debugging board below.ĬanaKit 3.5A Raspberry Pi 4 Power Supply (USB-C).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |